Ranger 4WD V6-3.0L VIN U (1997)
Seat Track: Service and Repair
Power Six-Way
REMOVAL
1. Remove heat shield covers to expose nuts from right rear of the front seat track by opening the locking tabs.
2. Position front seat track to full-up position.
3. Remove bolts retaining the front seat and front seat track to the floor.
4. Remove plug to expose bolt securing slide bar to floorpan. Remove bolt and boot.
5. Disconnect the wire harness from under front seat cushion rear. Remove the front seat from the vehicle.
6. Place the front seat upside down on a clean bench.