Ranger 4WD V6-3.0L VIN U (1997)
Outboard Brake Shoe And Lining
4. Using a C-clamp:
^
Position the frame of the C-clamp on the inboard side of the disc brake caliper. Do not place the clamp frame over the front brake hose.
^
Position the C-clamp screw on the outboard brake shoe and lining.
^
Compress the C-clamp only enough to give removal clearance for the disc brake caliper.
5. Remove the front brake hose flow bolt.
6. Disconnect and plug the front brake hose. Discard the copper washers.
7. From the inboard side of the disc brake caliper remove the two caliper slide pins.
CAUTION: Use care to retain as much of the original caliper slide pin grease as possible.
8. Slide the disc brake caliper off the front disc brake hub and rotor.
9. Slide the brake shoe and lining out of the front disc brake caliper anchor plate.
10. Remove the two caliper anchor plate bolts.
11. Remove the front disc brake caliper anchor plate from the front wheel hub and spindle.
INSTALLATION
1. Position the front disc brake caliper anchor plate on the front wheel hub and spindle.
2. Install the two caliper anchor plate bolts. Tighten the bolts to 98-132 Nm (73-97 ft. lbs.).
3. Position the brake shoe and lining in the front disc brake caliper anchor plate.
4. Slide the disc brake caliper over the brake shoe and lining.
5. Install the caliper slide pins. Tighten to 30-36 Nm (23-26 ft. lbs.).
6. Using new copper washers, install the flow bolt through the front brake hose fitting and into the disc brake caliper. Tighten the flow bolt to 30-40
Nm (22-29 ft. lbs.).
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Refill the brake master cylinder reservoir with clean Ford High Performance DOT 3 Brake Fluid C6AZ-19542-AA or equivalent DOT 3 fluid
meeting Ford specification ESA-M6C25-A.
10. Bleed the brake system.
11. Test the brakes before moving the vehicle.
