Ranger 4WD V6-3.0L VIN U (1997)
Cruise Control Switch: Service and Repair
Speed Control Switch
REMOVAL
NOTE: The left actuator switch, right actuator switch, and wiring assembly can be serviced independently. The bulb for switch graphics backlighting is
not serviceable as a separate item. To service a bulb, replace the left or right actuator switch.
1. Make sure the vehicle's front wheels are facing straight ahead, and the steering wheel is oriented in the straight-ahead position.
2. Disconnect the battery to starter relay cable. Wait at least one minute before proceeding to allow the air bag backup power supply to discharge.
3. Remove driver side air bag module.
4. Disconnect the wiring connector(s) at the sides of the switch(es) to be serviced.
5. Remove the (2) retaining screws per actuator switch, and remove switch from steering wheel.
INSTALLATION
1. Position the left and right speed control actuator switches on the steering wheel and install four Phillips head attaching screws.
NOTE: Install ground eyelet under the upper screw on the right switch.
2. Connect the wiring harness connectors to each switch by pushing onto the switch pins until the connector snaps in place.
3. Install the driver side air bag module.
