Ranger 4WD V6-3.0L VIN U (1997)
Coolant Reservoir: Service and Repair
REMOVAL
1. Drain the coolant from the radiator coolant recovery reservoir by disconnecting the overflow line at the radiator filler neck overflow nipple and
allowing it to siphon into a suitable container.
2. Remove the radiator coolant recovery reservoir attachments and remove the combination radiator coolant recovery reservoir.
INSTALLATION
WARNING: DO NOT STAND IN LINE WITH OR NEAR THE ENGINE COOLING FAN BLADE WHEN THE ENGINE IS RUNNING.
1. Position the radiator coolant recovery reservoir in the vehicle and install attaching screws. Tighten to 6-8 Nm (52-71 inch lbs.).
2. Connect the overflow tube to the radiator.
3. Fill and bleed the cooling system. Check for coolant leaks and proper coolant level after the engine reaches normal operating temperature.