Ranger 4WD V6-3.0L VIN U (1997)
Camshaft Bearing: Service and Repair
Rear Bearing Cover
REMOVAL
1. Remove transmission.
2. Remove flywheel.
3. Using a sharp chisel or punch and hammer, cut a hole in the center of the camshaft rear bearing cover.
4. Remove the camshaft rear bearing cover using Impact Slide Hammer T59L-100-B or T50T-100-A. The plug can also be pried from the bore using
a large punch. Use care to prevent damage to the plug bore.
INSTALLATION
Prior to installing camshaft rear bearing cover, the plug bore should be inspected for any damage that would interfere with the proper sealing of the
plug. If the bore is damaged it will be necessary to true the surface by boring for the next specified oversize plug. Oversize plugs are identified by the
"OS" stamped in the flat located on the cup side of the plug.
NOTE: Apply a light coating of Gasket Eliminator E1FZ-19562-A or equivalent meeting Ford specification WSK-M2G348-A4 to the sealing edge of
the plug before installation.
1. Install camshaft rear bearing cover using a suitable driver.
2. Install flywheel. Tighten flywheel attaching to 73-87 Nm (54-64 ft. lbs.).
3. Install transmission.