Ranger 4WD V6-3.0L VIN U (1997)
Blower Motor Resistor: Service and Repair
Blower Motor Resistor
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect the wire connector from the heater blower motor switch resistor, located on the A/C evaporator housing.
3. Remove two screws attaching the heater blower motor switch resistor to the A/C evaporator housing then remove the heater blower motor switch
resistor.
INSTALLATION
1. For installation, follow removal procedures in reverse order.
2. Check system for proper operation.
