Ranger 4WD V6-3.0L VIN U (1997)
Control Assembly: Service and Repair
Control Assembly, HVAC
Climate Control Assembly
REMOVAL
1. Disconnect battery ground cable.
2. Snap control opening finish panel away from instrument panel.
3. Remove four screws attaching heater control assembly to instrument panel.
4. Pull heater control from instrument panel and disconnect electrical connectors from the heater control.
5. Disconnect A/C plenum vacuum harness.
6. Disconnect heater temperature cable from heater control.
7. The knobs can be removed by pulling.
8. Remove heater control.
INSTALLATION
1. Push control knobs on appropriate shafts, if they were removed.
2. Connect heater temperature cable to heater control.
3. Connect electrical connector(s) and vacuum hose harness to heater control assembly.
4. Position heater control in instrument panel opening and install four retaining screws.
5. Install control opening finish panel by snapping it into place.
6. Connect battery ground cable.
7. Check system for proper operation.
Climate Control Assembly Bulbs
REMOVAL
