Ranger 4WD V6-3.0L VIN U (1997)
Oil Pressure Sender: Service and Repair
REMOVAL
1. Make sure the engine is turned off.
NOTE: The pressure switch-type unit used with the indicator lamp system is not interchangeable with the variable resistance-type unit called a
sender, which is used with the gauge system. Refer to the Master Parts Catalog for proper parts usage. Installation of the wrong part will result in
an inoperative oil pressure indicating system and a damaged switch unit or gauge.
2. Remove inside engine cover.
3. Disconnect the wire at the switch unit terminal
4. Remove the oil pressure sensor from its mounting.
5. Apply Pipe Sealant with Teflon D8AZ-19554-A or equivalent meeting Ford specification WSK-M2G350-A2 to new switch unit threads.
INSTALLATION
1. For installation follow removal procedures in reverse order. Tighten switch to 11-24 Nm (8-18 ft. lbs.).
