Ranger 4WD V6-3.0L VIN U (1997)
Hazard Warning Flasher: Service and Repair
NOTE:
1. When replacing the indicator flasher, make sure to install one having the same color-code and number as the one removed.
2. Do not replace multi-function switch or wiring if:
^
Turn signal lamps do not flash on demand with ignition key turned on, or
^
Indicator flasher makes normal pulsing noise, or
^
Turn signal lamps prove satisfactory when bench-tested or checked by activating brake stoplamp switch for rear only.
To remove the indicator flasher grasp indicator flasher and pull straight out. To Replace flasher, align indicator flasher terminals to connector and push
straight in.
1. Check the power at indicator flasher output terminal (pulsing noise indicates power is coming into the indicator flasher).
2. If there is no or very weak power at the indicator flasher output terminal (12-volt test lamp will not light or is dim), replace the indicator flasher.
