Ranger 4WD V6-3.0L VIN U (1997)
Discard wheel hub grease seal and replace upon assembly.
7. Remove excluder seal.
8. Remove the inner wheel bearing.
9. Inspect the wheel bearing cups for pits or cracks. If necessary, remove them with Internal Puller D80L-943-A or equivalent and Impact Slide
Hammer T50T-100-A.
NOTE: If new wheel bearing cups are installed, install new cone and roller assemblies.
ASSEMBLY
1. Lubricate the wheel bearings with High Temperature Constant Velocity Grease E43Z-19590-A or equivalent meeting Ford specification
ESP-M1C207-A. Clean all grease from the hub. Pack the cones and rollers. If a bearing packer is not available, work as much lubricant as possible
between the rollers and the cages.
2. If wheel bearing cups are to be installed, position wheel bearing cups in rotor and drive in place with Bearing Cup Replacer T80T-4000-P and
Driver Handle T80T-4000-W.
3. Position excluder seal on spindle and drive into position using Spindle Seal Replacer T95T-3132-D.
4. Position the inner wheel bearing in the inner wheel bearing cup in the rotor. Install the wheel hub grease seal by driving in place with Seal
Replacer T80T-4000-T and Driver Handle T80T-4000-W.
5. Carefully install the rotor onto the front wheel spindle.
6. Install outer wheel bearing into rotor.
7. Install the Automatic Locking Hubs.
