Ranger 4WD V6-3.0L VIN U (1997)
5. From inside vehicle, remove accelerator cable end from top of accelerator pedal assembly.
6. Collapse retaining clips at dash panel and push accelerator cable through dash panel into engine compartment. Remove accelerator cable.
INSTALLATION
CAUTION: Make sure accelerator cables are routed as shown in the illustration.
1. Install accelerator cable through dash panel and into passenger compartment, and making sure retaining clips are fully seated.
2. From inside vehicle, attach accelerator cable end to accelerator pedal assembly, seating returner on accelerator cable end onto accelerator pedal
assembly.
3. Install accelerator cable into accelerator cable bracket on intake manifold, making sure that tab or pin on accelerator cable aligns with hole in
accelerator cable bracket.
4. Attach accelerator cable end to throttle lever ball stud at throttle body. Carefully push only on the end of the accelerator cable when snapping
accelerator cable end over ball stud.
5. Position the accelerator control splash shield and install the accelerator control splash shield screws. Tighten the accelerator control splash shield
to 7-9 Nm (62-79 lb in).
