Ranger 4WD V6-3.0L VIN U (1997)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
NOTE: When battery voltage is removed from the Powertrain Control Module (PCM), all learned values will be cleared and reset to
predetermined values. When battery voltage is restored to the PCM, the vehicle may exhibit certain driveability concerns. It will be necessary to
drive the vehicle to allow the PCM to relearn values for optimum driveability and performance.
2. Raise and support the vehicle.
3. Disconnect Crankshaft Position (CKP) sensor electrical connector.
4. Remove two CKP sensor bolts and remove sensor.
INSTALLATION
1. Position CKP sensor on engine .
2. Install two CKP sensor screws and tighten to 5-7 Nm (45-61 Lb in).
3. Lower the vehicle.
4. Route CKP sensor wiring harness and connect electrical connector.
5. Connect battery ground cable.
