Ranger 4WD V6-3.0L VIN U (1997)
Seat Belt: Description and Operation
Fastening and Unfastening Safety Belts
After entering the vehicle, adjust the front seat to obtain the best position for driving comfort, access to controls and visibility. Then, use the following
procedure for fastening safety belts.
1. To fasten the belt, pull the lap/shoulder belt from the safety belt retractor so the shoulder portion of the safety belt crosses the shoulder and chest.
Be sure the belt is not twisted. If it is, remove the twist. Insert the belt tongue into the proper buckle until a snap is heard and the safety belt is
latched.
WARNING: use the shoulder belt on the outside shoulder only. Never wear the shoulder belt under the arm. Never swing it around your
neck over the inside shoulder. Never use a single belt for more than one person. Make sure the lap portion of the belt is fitted snugly and
as low as possible around the hips, not on the waist. Failure to follow these precautions could increase the chance and/or severity of injury
in a collision.
On Ranger SuperCab: Adjust the driver and/or passenger shoulder belt height adjuster up or down until the shoulder belt rests across the middle of
your shoulder. To adjust, pinch the release button and adjust down to any of five (5) positions. You do not have to pinch the button for up
adjustments.
