Ranger 4WD V6-3.0L VIN U (1997)
5. Remove the bolt retaining the front safety belt retractor and tongue.
6. Remove front safety belt retractor and tongue from the vehicle.
INSTALLATION
1. Position front safety belt retractor and tongue to the vehicle and install the bolt. Use Seat Belt Bolt Bit (No. 50 Torx) T77L-2100-A and tighten to
40 Nm (30 lb ft).
2. Feed the floor anchor end of the front safety belt retractor and tongue through the quarter trim panel. Install quarter trim panel.
3. Position the floor anchor anti-rotation tab to the front floor pan. Install the bolt and tighten to 40 Nm (30 lb ft).
4. Position safety belt D-ring. Install nut/bolt and tighten to 40 Nm (30 lb ft).
5. Install front seat shoulder strap guide cover by hooking the upper retaining tab over the top of the belt guide and press both lower corners between
the thumb and index finger, to snap lower retaining tabs behind the belt guide.
6. Check the restraint system for proper operation.
Seat Belt With Anchor Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 27/64 in drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Blow out the chips.
5. Install the attachment parts in the order shown, whichever is applicable. Tighten the replacement bolt to 34-46 Nm (25-34 lb ft).
Parts Replacement Chart
Original parts are to be replaced with the repair parts indicated in the safety belt parts replacement chart. Unless specified in the chart, use original
parts.
6. When repairing a multiple belt and attachment, install nut to the bolt in the tunnel area from the underside of the floorpan. Tighten to specification
