Ranger 4WD V6-3.0L VIN U (1997)
8. Position the slide bar boot to the slide bar. Install the Torx slide bar boot bolt through the boot, slide bar, rubber spacer, and into the weld nut
provided in the floor.
9. Hand start the bolt into the weld nut. Rotate the slide bar boot enough to allow the head of the Torx slide bar boot bolt to be seen.
10. Pull the slide bar against the head of the slide bar boot bolt. If the slide bar is not against the bolt head, it may be possible for the shoulder of the
bolt to "bottom out" on the slide bar, resulting in the slide bar not being in required alignment.
11. Tighten the Torx bolt to 40 Nm (30 lb ft).
12. Connect the electrical connector for the safety belt buckle switch (driver seat only).
13. Check restraint system for proper operation.
