Ranger 4WD V6-3.0L VIN U (1997)
6. Install one spacer, T75L-3517-A3, over the input shaft as a pilot for installing the sizing tube.
-
Slowly install the sizing tube Tool T75L-3517-A4, over the sleeve valve end of the worm shaft onto the valve sleeve rings. Make sure that the
rings are not being bent over as the tube is slid over them.
-
Allow the sizing tube to sit over the rings for five (5) minutes.
7. Remove the sizing tube and check the condition of the rings. Make sure that the rings turn freely in the grooves.
NOTE:
-
No further service or disassembly of the worm valve assembly is possible. Valve centering will be destroyed if disassembly is attempted.
