Ranger 4WD V6-3.0L VIN U (1997)
Suspension Spring ( Coil / Leaf ): Service and Repair
Rear Spring Anti-Squeak Insert
1. Raise the vehicle by the frame so rear axle hangs freely.
2. Bend the spring clip to provide clearance between the rear spring leaves, allowing insertion of the rear spring anti-squeak inserts. A pry-bar may
be used between the leaves to provide additional clearance for insertion of rear spring anti-squeak inserts.
3. Slide the rear spring anti-squeak insert between the leaves until the liner extends approximately 6.35 mm (0.25 inch) beyond the tip of the lower
leaf.
NOTE: Do not attempt to install a rear spring anti-squeak insert between the lowest primary leaf and the short 12.70 mm (0.50 inch) thick
secondary leaf found at the bottom of the leaf stack on some assemblies.
4. Set rear axle on a stand to load the rear leaf springs. Contact leaves at the clip locations.
5. Reinstall production clips or install the replacement service clip.
NOTE: On some of the rear spring anti-squeak inserts, sections of the edge used to center the liner on the spring leaves may need to be trimmed
off to accommodate spring clip.
