Ranger 4WD V6-3.0L VIN U (1997)
Cam Assembly Installation
13. Install the two thrust spacers and push or press the cam assembly onto the locknut by lining up the key in the fixed cam with the keyway of the
front wheel spindle.
CAUTION: Extreme care must be taken when aligning the fixed cam key with the keyway of the front wheel spindle to prevent damage to the
fixed cam.
14. Install the axle shaft spacer.
15. Clip the snap ring onto the end of the shaft of the front wheel spindle.
16. Install the automatic locking hub assembly over the front wheel spindle. Align three hub assembly legs with three pockets in cam assembly. Install
the retainer washers.
17. Install the wheel and tire assembly. Install and tighten lug nuts to 135 Nm (100 ft. lbs.).
