Ranger 4WD V6-3.0L VIN U (1997)
5. Remove the pump gears.
NOTE:
^
The pump gears are part of the pump assembly and are not serviced separately.
^
A-rough casting on the pump surface crescent is not a flaw.
6. Remove the drive gear O-ring and discard.
7. Inspect the pump gears for scoring and cracks. Replace pump assembly if damaged.
8. Inspect the fluid pump to converter housing bushing and converter hub to converter housing seal. Replace converter housing assembly if
necessary.
NOTE: Fluid pump-to-converter housing bushing is not serviced separately. If service is required the converter housing assembly must be
replaced.