Ranger 4WD V6-3.0L VIN U (1997)
Axle Pivot Bushing: Service and Repair
REMOVAL
1. Lower the axle housing after removing the axle pivot bolt and nut, loosening the radius arm bushing.
2. Install Forcing Screw T78P-5638-A1, Pivot Bushing Remover T80T-5638-A2 and Receiver Cup T78P-5638-A4 onto the pivot bushing. Turn the
forcing screw and remove the pivot bushing.
INSTALLATION
1. Place pivot bushing in axle housing. Install Receiver Cup T78P-5638-A4, Forcing Screw T78P-5638-A1 and Front Suspension Bushing Tool
T80T-5638-A into housing and install bushing.
2. After installing, the "lead in" end of the bushing must be flared to prevent movement. Install Forcing Screw T78P-5638-A1, suitable Flaring Tool
and suitable Receiving Cup and flare the bushing.
3. Install the axle pivot bolt and nut; tighten the axle pivot nut to 163-203 Nm (120-150 ft. lbs.).