Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
Air Bag Control Module: Service and Repair
Removal And Installation
REMOVAL
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or
replacing any front or side air bag Supplemental Restraint System (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped). The Restraints Control Module (RCM) orientation is critical for correct system operation. If a
vehicle equipped with an air bag supplemental restraint system (SRS) has been involved in a collision in which the center tunnel area has
been damaged, inspect the mounting and bracket for deformation. If damaged, the RCM must be replaced whether or not the air bags have
deployed. In addition, make sure the area of the RCM mounting is restored to its original condition.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the utility tray.
1
Unscrew the two retainers.
2
Remove the utility tray.
3. Remove the two bolts retaining the Restraint Control Module (RCM) bracket.
