Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
Steering Angle Sensor: Service and Repair
Removal
CAUTION: The steering column must be in the locked position, or the lower end of the column wired in such a way that the steering column
does not rotate, resulting in damage to the air bag sliding contact.
NOTE: Discard the upper intermediate shaft to steering column shaft bolt upon removal. Do not reuse; install a new bolt.
1. Remove the upper intermediate steering shaft to column shaft bolt.
1
Remove and discard the steering column shaft pinch bolt.
2
Slide the intermediate shaft yoke from the steering column.
2. Remove the shock absorber electronic steering sensor.
1
Disconnect the electrical connector.
2
Remove the screws.
3
Remove the shock absorber electronic steering sensor.