Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
12. Tighten the screws.
13. NOTE: Apply petroleum jelly on the separator plate surface to hold the gasket in place.
NOTE: Use new separator plate main control to case gasket on installation.
Install new main control to case gasket.
14. Remove the guide pins from main control valve body.
1
Remove large guide pin.
2
Remove small guide pin.
15. Rotate the main control valve body so the valve body separator plate is facing down.
16. CAUTION: All solenoid electrical connectors must face upward on installation.
NOTE: All shift solenoids are interchangeable.
NOTE: If the TCC valve came out during disassembly, use caution when installing the torque converter clutch solenoid.
Install the SSB, CCS, TCC and EPC solenoids.
1
Install the TCC solenoid.
2
Install the SSB and CCS solenoids.
3
Install the EPC solenoid.