Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
11. CAUTION: Do not damage the connector or harness.
Remove the transmission case (16 pin) electrical connector.
^
Compress the tabs on the transmission case (16 pin) electrical connector.
^
Push the transmission case (16 pin) electrical connector out of transmission case.
Installation
1. NOTE: Make sure the tab is in the lock position.
NOTE: Install new O-rings on the transmission case (16 pin) electrical connector.
Install the transmission case (16 pin) electrical connector.
^
Lubricate the transmission case (16 pin) electrical connector O-rings with petroleum jelly.
2. Press the transmission case (16 pin) electrical connector through the case until a click is heard.
3. CAUTION: Align the slot on the T&S sensor electrical connector with the slot in the 16 pin case connector.
Install the TSS sensor wire.
