Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
Pressure Regulating Solenoid: Service and Repair
Replacement
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Drain the transmission fluid.
4. Remove the transmission fluid filter.
1
Remove the transmission fluid filter screw.
2
Remove the transmission fluid filter.
5. NOTE: Main control assembly does not need to be removed for solenoid service.
Remove wire loom guide and protector.
^
Carefully lift up on wire loom guide and protector and disengage the retaining pins from the solenoid clamps.
6. Disconnect the appropriate solenoid electrical connector.
1
Disconnect shift solenoids electrical connectors.
2
Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3
Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
