Ranger 4WD V6-4.0L (2009)
1. Remove the 60 percent bench armrest. For additional information, refer to Seat Armrest - 60 Percent See: Interior Moulding / Trim/Arm
Rest/Service and Repair.
2. Remove the backrest recliner handle screw and the handle.
3. Remove the 2 side shield screws.
4. Pull out on the side and the rear of the side shield to detach the 2 clips (1 shown).
5. Remove the outboard recliner cable anchor and swivel and detach the recliner cable end.
6. Remove the outboard pin-type retainer and position the trim cover flap aside.
7. Remove the 2 outboard backrest-to-cushion bolts.
8. Remove the inboard seat backrest latch release cable anchor and swivel and detach the cable end.
9. Remove the front inboard backrest-to-cushion bolt.
SuperCab seat
10. Remove the inboard rear bolt cover.