Ranger 4WD V6-4.0L (2009)
3. Position the cable aside.
14. Disconnect the inboard seat back latch release cable end.
1. Detach the cable from its anchor point.
2. Swivel the cable end and remove from the latch retainer.
3. Position the cable aside.
15. Remove the 2 inboard seat backrest-to-cushion bolts.
16. Remove the 2 outboard seat backrest-to-cushion bolts.
17. NOTE: If equipped, note position of the lumbar cable where it comes through the seat cushion.
Remove the backrest assembly.
Installation
All seats
1. Install the backrest assembly.
2. Install the 2 outboard seat backrest-to-cushion bolts.
-
Tighten to 25 Nm (18 lb-ft).
3. Install the 2 inboard seat backrest-to-cushion bolts.
-
Tighten to 25 Nm (18 lb-ft).
4. Install the inboard seat backrest latch release cable.
1. Position the cable.
2. Install the seat back latch release cable end and swivel the cable.
3. Attach the cable at its anchor point.
5. Install the outboard seat backrest latch release cable.
