Ranger 4WD V6-4.0L (2009)
9. NOTICE: An Occupant Classification Sensor (OCS) system service kit will have the OCS bladder attached to the seat cushion foam pad.
Do not separate the OCS bladder from the seat cushion foam pad. Failure to do so may result in component failure.
Remove all rows of hog rings and remove the cushion trim cover.
Passenger seat
10. NOTE: For correct installation, note position of wire harness routing.
Release the 2 wire harness routing clips from the seat cushion frame.
11. Release the pressure sensor bracket retainer and slide the pressure sensor off the bracket.
12. Remove the OCSM.
1. Remove the 2 screws.
2. Release the bracket retainer and slide the OCSM off the bracket.
13. NOTICE: A production Occupant Classification Sensor (OCS) bladder is shown. An OCS service kit will have the OCS bladder attached
to the seat cushion foam pad. Do not separate the OCS bladder from the seat cushion foam pad. Failure to do so can result in component
failure.
Release the 3 OCS bladder pin-type retainers from the seat cushion frame.
