Ranger 4WD V6-4.0L (2009)
Truck Bed: Removal and Replacement
Pickup Bed
Removal and Installation
1. Remove the tailgate.
2. Disconnect the tail lamp wiring harness electrical connector.
3. Remove the fuel filler cap.
4. NOTE: Mark the position of the fuel filler cap tether for correct installation.
Remove the fuel filler neck screws.
5. NOTE: The pickup bed bolts are not identical and new bolts must be installed in the same location that they were removed from.
Remove and discard the 10 pickup bed bolts.
-
To install, tighten the new bolts to 63 Nm (46 lb-ft).