Ranger 4WD V6-4.0L (2009)
Brake Pedal Assy: Service and Repair
Brake Pedal and Bracket
NOTE: Automatic transmission shown, manual transmission similar.
Removal and Installation
All vehicles
1. NOTICE: Do not service the brake pedal or brake booster without first removing the stoplamp switch and speed control deactivator
switch. These switches must be removed with the brake pedal in the at-rest position. Switch plungers must be compressed for the switch
to rotate in the bracket. Attempting to remove the switch when the plunger is extended (during pedal apply) will result in damage to the
switch.
Remove the stoplamp switch.
2. If equipped, remove the speed control deactivator switch.
Manual transmission
3. Disconnect the Clutch Pedal Position (CPP) switch.
4. NOTE: The clutch pedal master cylinder push rod retaining clip is not reusable.
Disconnect the clutch pedal master cylinder push rod.
5. Remove the clutch master cylinder from the brake and clutch pedal bracket by rotating it 45 degrees clockwise.
