Ranger 4WD V6-4.0L (2009)
Coolant Reservoir: Service and Repair
Coolant Expansion Tank - 4.0L
Removal and Installation
1. Remove the Air Cleaner (ACL).
2. If equipped, remove the speed control servo bolt and position the servo aside.
-
To install, tighten to 11 Nm (97 lb-in).
3. Disconnect the windshield washer hose.
4. Disconnect the windshield washer motor electrical connector.
5. Disconnect the overflow hose at the coolant expansion tank and drain the coolant into a suitable container.
6. Remove the 2 bolts, the 2 nuts and the coolant expansion tank.
-
To install, tighten to 7 Nm (62 lb-in).
7. To install, reverse the removal procedure.
