Ranger 4WD V6-4.0L (2009)
Fan Shroud: Service and Repair
Cooling Fan Shroud - 4.0L
Removal and Installation
1. Remove the Air Cleaner (ACL) outlet tube.
2. Remove the accessory drive belt.
3. Using the Fan Pulley Holding Wrench and the Fan Clutch Nut Wrench, remove the fan and fan clutch assembly and position it inside the shroud.
-
To install, tighten to 55 Nm (41 lb-ft).
4. Remove the 2 fan shroud bolts. Lift the fan and fan clutch assembly and the fan shroud together and remove from the vehicle.
-
To install, tighten to 6 Nm (53 lb-in).
5. To install, reverse the removal procedure.
