Ranger 4WD V6-4.0L (2009)
15. Install the dual converter Y-pipe.
All vehicles
16. If equipped, position the A/C tube bracket and install the nut.
-
Tighten to 20 Nm (177 lb-in).
17. Position the transmission fluid cooler tube and install the bolt.
-
Tighten to 47 Nm (35 lb-ft).
18. Lower the engine and remove the Engine Support Bar and the 2 Adapters for 303-209A.
19. Remove the Engine Lifting Bracket and install the coolant tube bolt.
-
Tighten to 28 Nm (21 lb-ft).
20. Install the RH engine support insulator nuts.
-
Tighten to 110 Nm (81 lb-ft).
21. Remove the Engine Lifting Bracket and install the power steering and A/C compressor bracket bolt.
-
Tighten to 42 Nm (31 lb-ft).
22. Install the 2 LH engine support insulator nuts.
-
Tighten to 110 Nm (81 lb-ft).
23. Install the oil level indicator.
24. Position the fan shroud and install the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
25. Install the oil pan. For additional information, refer to Oil Pan See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan.
26. Install the starter.
27. Install the ACL outlet pipe.
28. Connect the battery ground cable.
Engine Support Insulators