Ranger 4WD V6-4.0L (2009)
Apply silicone gasket and sealant to the oil pan and engine block mating surfaces.
4. NOTICE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use
silicone gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future
oil leakage.
Apply silicone gasket and sealant to the front cover in 2 places.
5. NOTE: Make sure the coolant bypass hose is attached to the coolant pump.
NOTE: Make sure the stud bolts are installed in their original positions.
Position the engine front cover and install the 5 bolts and 5 stud bolts.
-
Tighten to 19 Nm (168 lb-in).
6. Install the 5 cylinder block cradle-to-front cover bolts.
-
Tighten bolts to 14 Nm (124 lb-in).
7. Attach the wiring harness to the LH cylinder head and install the bolt.
-
Tighten to 10 Nm (89 lb-in).
8. Position the bypass hose clamp.
