Ranger 4WD V6-4.0L (2009)
8. NOTICE: Do not pull the driver air bag module electrical connectors out by the locking buttons. Damage to the locking buttons may
occur.
Using a small screwdriver as shown, lift up and release the locking buttons on the driver air bag module electrical connectors. With the locking
buttons released, remove the electrical connectors and the driver air bag module.
9. Open the glove compartment door fully to access the passenger air bag electrical connector.
10. Release the tab and disconnect the passenger air bag module electrical connector.
11. Install the RCM fuse 8 (10A) to the SJB.
12. Connect the battery ground cable.
Reactivation Procedure
1. Remove the RCM fuse 8 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. Connect the passenger air bag module electrical connector.
4. Close the glove compartment door.
