Ranger 4WD V6-4.0L (2009)
Wheel Hub: Service and Repair
Wheel Bearing and Wheel Hub
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary. Do not use
a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Remove the wheel and tire.
2. NOTICE: Do not reuse the torque-prevailing designed halfshaft nut and washer assembly or damage to the component may occur.
Remove and discard the halfshaft nut and washer.
-
To install, tighten to 250 Nm (184 lb-ft).
3. NOTICE: Do not use a hammer to separate the outboard CV joint from the wheel bearing and hub. Damage to the outboard CV threads
and to internal components may result.
