Ranger 4WD V6-4.0L (2009)
I26 CHECK FOR CORRECT OCSM OPERATION
-
Disconnect the OCSM connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the OCSM connector and make sure it seats correctly.
-
Verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new OCSM. CONNECT all modules. CLEAR the DTCs.
REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
I27 CHECK FOR CORRECT 4X4 CONTROL MODULE OPERATION
-
Disconnect all of the 4X4 control module connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all of the 4X4 control module connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new 4X4 control module. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
I28 CHECK FOR CORRECT IC OPERATION
-
Disconnect all of the IC connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all of the IC connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new IC. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
Pinpoint Test J: The Satellite Digital Audio Receiver System (SDARS) Module Does Not Respond To
