Ranger 4WD V6-40L (2009) Camshaft Position Sensor Overview
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor - 4.0L
Removal and Installation
1. Disconnect the Camshaft Position (CMP) sensor electrical connector.
2. Remove the bolt, the CMP sensor and discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
3. NOTE: Lubricate the new O-ring seal with clean engine oil prior to installation.
To install, reverse the removal procedure.
-
Install a new O-ring seal.
