Ranger 4WD V6-4.0L (2009)
-
To install, tighten to 3 Nm (27 lb-in).
4. NOTICE: Do not use a high-speed driver to install the new screws or the Throttle Position (TP) sensor may be damaged.
NOTE: Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the TB.
To install, reverse the removal procedure.
-
Install a new TP sensor and screws.
