Ranger 4WD V6-4.0L (2009)
Transmission Speed Sensor: Service and Repair
Intermediate Shaft Speed Sensor
5R44E and 5R55E
Intermediate Shaft Speed Sensor
Intermediate Shaft Speed Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the intermediate shaft speed sensor electrical connector.
3. Remove the intermediate shaft speed sensor screw.
4. Remove the intermediate shaft speed sensor from the transmission.
Installation
1. NOTE: Inspect the intermediate shaft speed sensor O-ring for damage. If damaged, install a new O-ring.
Inspect and lubricate the O-ring with petroleum jelly.
Install the intermediate shaft speed sensor into the transmission.
2. Install the intermediate shaft speed sensor screw.
-
Tighten to 10 Nm (89 lb-in).
3. Connect the intermediate shaft speed sensor electrical connector.
4. Lower the vehicle.