Ranger 4WD V6-4.0L (2009)
-
If necessary, push down on the top and up on the bottom of the passenger air bag cover while pushing out on the passenger air bag module,
releasing the clips from the instrument panel.
Installation
1. Install the passenger air bag module and 2 bolts.
-
Tighten to 8 Nm (71 lb-in).
2. Connect the passenger air bag module electrical connector.
3. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
