Ranger 4WD V6-4.0L (2009)
-
Buckles
-
Belt tension sensor (BTS) (if equipped)
-
Front safety belt buckle support assemblies (slide bar) (if equipped)
-
Safety belt shoulder belt height adjusters (if equipped)
-
Child safety seat tether bracket assemblies
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing, a new safety
belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original
structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching
hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
NOTICE: To prevent system failure, it is necessary to carry out the Occupant Classification Sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover is installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS
system reset command.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat.
2. Release the inboard side rear hook-and-loop strip.
3. Release the inboard side bottom J-clip for access to the safety belt buckle pretensioner.
4. Detach the pin-type retainers and safety belt buckle pretensioner wire harness from the seat cushion frame.
-
For driver seat, disconnect the seat position sensor electrical connector.
-
For passenger seat, disconnect the safety belt buckle pretensioner electrical connector.
-
Note wire harness routing for correct installation.
