Ranger 4WD V6-4.0L (2009)
8. Install the seat track assembly and 4 bolts.
-
Tighten to 6 Nm (53 lb-in).
9. Attach the seat cushion trim cover rear J-clip.
10. Install the seat wiring harness retainer clip and attach the seat wiring harness connector to the seat cushion frame.
11. Install the front seat backrest.
12. Install the passenger seat.
13. Repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering
and Repowering See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering
and Repowering in the General Procedures.
14. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
NOTICE: To prevent system failure, the following precautions must be taken before carrying out the Occupant Classification Sensor
(OCS) system reset:
-
Make sure the voltage to the Occupant Classification System Module (OCSM) is above 8 volts and less than 18 volts.
-
Make sure the Occupant Classification Sensor (OCS) system is not at a temperature below 6°C (42°F) or above 36°C (97°F) when
initiating the OCS system reset process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be
exposed and kept at a temperature within the limits, 6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat during
the process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition ON before the carrying out the OCS system reset.
Carry out the Occupant Classification Sensor (OCS) System Reset.
15. If the first system reset attempt was unsuccessful, carry out a thorough visual inspection of the following and repair any concerns found.
-
OCS system connector wiring for damage
-
Pressure sensor hose for kinks and/or damage
-
Seat-related wiring harness and body wiring harness terminals and connectors for damage
16. Carry out a second OCS system reset. If the second attempt is unsuccessful, install a new OCS system service kit.
17. Cycle the ignition from ON to OFF.
18. NOTE: The ignition must be cycled after the OCS system reset.
Cycle the ignition from OFF to ON.
19. Prove out the SRS as follows:
