Ranger 4WD V6-4.0L (2009)
4. Remove the manual control outer lever nut and manual control outer lever.
5. Remove the screws and the TR sensor.
Installation
1. NOTICE: The Transmission Range (TR) sensor must fit flush against the boss on the case to prevent damage to the sensor.
Install the TR sensor and loosely install the screws.
2. NOTICE: Tightening one screw before tightening the other may cause the Transmission Range (TR) sensor to bind or become damaged.
NOTE: The manual control lever must be in the NEUTRAL position.
Using the TR Sensor Alignment Gauge, align the TR sensor and tighten screws in an alternating sequence.
-
Tighten to 10 Nm (89 lb-in).
3. Install the manual control outer lever and nut.
-
Tighten to 48 Nm (35 lb-ft).
