Ranger 4WD V6-4.0L (2009)
Alignment: Service and Repair
Ride Height Measurement
Ride Height Measurement
Front Ride Height Measurement
NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank
of fuel.
1. Position a suitable surface gauge (such as Starrett 57D Surface Gauge), on a flat, level surface and adjust the gauge's arm until the scriber point is
located in the center of the lower arm rearward bolt.
-
Lock the surface gauge in this position.
2. With the surface gauge positioned on a flat, level surface, record the measurement of the surface gauge position (measurement 2).
3. Position the surface gauge on the same flat, level surface as used in Step 1, adjust the gauge's arm until the scriber point is located on the wheel
knuckle lowest point, behind the lower ball joint nut.
-
Lock the surface gauge in this position.
4. With the surface gauge positioned on a flat, level surface, record the measurement of the surface gauge position (measurement 3).
