Ranger 4WD V6-4.0L (2009)
5. NOTICE: Do not install the driver air bag module electrical connectors by the locking buttons. Damage to the locking buttons may occur.
NOTICE: The driver air bag module electrical connector locking buttons must be in the released position when the connector is being
installed or connector damage may occur.
With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking
buttons.
6. Install the 2 driver air bag module bolts (1 shown).
-
Tighten to 6 Nm (53 lb-in).
7. Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
8. Turn the ignition from OFF to ON.
9. Install RCM fuse 8 (10A) to the SJB.
10. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
11. Prove out the SRS as follows:
Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and visually monitor the air bag warning indicator with the
air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS
fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash at a 5Hz rate (RCM not configured).
The air bag warning indicator may not illuminate until approximately 30 seconds after the ignition has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and an SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.
Clear all continuous RCM and Occupant Classification System Module (OCSM) DTCs using a scan tool.
