Ranger 4WD V6-40L (2009) - Transmission Fluid Drain and Refill
Fluid - A/T: Service and Repair
Transmission Fluid Drain and Refill
5R44E and 5R55E
Transmission Fluid Drain and Refill
Drain
NOTICE: Use only transmission fluid. Do not use any supplemental transmission fluid additives, treatments or cleaning agents. The use of these
materials may affect the operation of the transmission, resulting in internal component failure.
1. With the vehicle in PARK, position it on a hoist.
2. NOTE: If equipped, the transmission servo heat shield must be unclipped from the transmission fluid pan rail and positioned aside for
transmission fluid pan removal.
If equipped, loosen the nut and position the heat shield aside.
3. Place a drain pan under the transmission fluid pan.
4. Drain transmission fluid.
-
Remove all the transmission fluid pan screws except for 2 in the front. Loosen the 2 front transmission fluid pan screws. Pry the rear of the
transmission fluid pan down and allow fluid to drain. After fluid is drained, remove the front 2 transmission fluid pan screws.
5. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage, if not damaged, the gasket should be reused.
Remove the transmission fluid pan.
1. Remove the transmission fluid pan.
2. Remove the transmission fluid pan gasket.
