Ranger 4WD V6-4.0L (2009)
5. NOTICE: The Torque Converter Clutch (TCC) solenoid and converter modulator valve may pop out of its bore. This may damage the
solenoid or converter modulator valve.
NOTICE: Shift Solenoid C (SSC) may pop out of its bore. This may damage the solenoid.
Remove the shift solenoids.
1. Remove the wire harness.
2. Remove the solenoid clamp screws.
3. Remove the solenoid clamp.
4. Remove the appropriate solenoid(s).
Installation
1. Install the new solenoid(s).
2. NOTE: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
Install the solenoid clamp.
1. Position the solenoid clamp on the main control valve body.
2. Install the solenoid clamp screws.
-
Tighten to 7 Nm (62 lb-in).
3. Connect the 6 solenoid electrical connectors.
1. Connect the SSA, SSB, SSC and SSD electrical connectors.
