Ranger 4WD V6-4.0L (2009)
10. NOTICE: Tightening one screw before tightening the other may cause the Transmission Range (TR) sensor to bind or become damaged.
NOTE: The manual control lever must be in the NEUTRAL position.
Using the TR Sensor Alignment Gauge, align the TR sensor and tighten screws in an alternating sequence.
-
Tighten to 10 Nm (89 lb-in).
11. Install the manual control outer lever and nut.
-
Tighten to 48 Nm (35 lb-ft).
12. Connect the TR sensor electrical connector.
13. Connect the selector lever cable to the manual control lever.