Ranger 4WD V6-4.0L (2009)
1. Disconnect the Shift Solenoid A (SSA), Shift Solenoid B (SSB), Shift Solenoid C (SSC) and Shift Solenoid D (SSD) electrical connectors.
2. Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3. Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
8. Remove the manual control valve detent lever spring.
1. Remove the manual control valve detent lever spring screw.
2. Remove the manual control valve detent lever spring.
9. Remove the low/reverse servo.
1. Remove the low/reverse servo cover screws.
2. Remove the low/reverse band servo cover and gasket. Discard the low/reverse servo separator plate cover gasket.
10. Remove the low/reverse band servo piston and rod.
11. Do not remove the 2 (gold) screws specified.
